Apexi Power FC SR20DET D-Jetro IAT Intake Air Temp Sensor Pinout and Wiring
Product Description
When installing a Apexi Power FC D-Jetro into an SR20DET powered car you will need to wire in a IAT ( Intake Air Temp ) sensor into the factory ECU's wiring harness. We are posting this because with a lot of these ECU's being purchased second hand, the manual sometimes does not come with it.
The Apexi IAT sensor harness has 2 wires. 1 Red and 1 Brown.
Run the BROWN wire into a ground coming from the ECU ( any solid black wire in the ECU loom ) or ground it to the chassis.
The RED wire from the IAT sensor should be wired into PIN#26 on the pinout above. In some cases you will need to add a pin to this location. If there is a wire here, cut it and splice your red wire into the ECU.
S13 SR20DET ECU Pinout:
*Be sure you are reading the pinout correctly. Pin#3 should have a Yellow/Red wire coming from it. Pin#16 and #20 should have White Wires coming from it.
The Apexi IAT sensor harness has 2 wires. 1 Red and 1 Brown.
Run the BROWN wire into a ground coming from the ECU ( any solid black wire in the ECU loom ) or ground it to the chassis.
The RED wire from the IAT sensor should be wired into PIN#26 on the pinout above. In some cases you will need to add a pin to this location. If there is a wire here, cut it and splice your red wire into the ECU.
S13 SR20DET ECU Pinout:
*Be sure you are reading the pinout correctly. Pin#3 should have a Yellow/Red wire coming from it. Pin#16 and #20 should have White Wires coming from it.